001     491054
005     20250724131727.0
024 7 _ |a 10.1016/j.matdes.2022.111535
|2 doi
024 7 _ |a 0264-1275
|2 ISSN
024 7 _ |a 1873-4197
|2 ISSN
024 7 _ |a 10.3204/PUBDB-2022-08229
|2 datacite_doi
024 7 _ |a WOS:000991089800001
|2 WOS
024 7 _ |a openalex:W4313367706
|2 openalex
037 _ _ |a PUBDB-2022-08229
041 _ _ |a English
082 _ _ |a 690
100 1 _ |a Heinze, Stefan
|0 P:(DE-H253)PIP1081283
|b 0
|e Corresponding author
245 _ _ |a Influence of the deposition process and substrate on microstructure, phase composition, and residual stress state on as-deposited Cr-Al-C coatings
260 _ _ |a Amsterdam [u.a.]
|c 2023
|b Elsevier Science
336 7 _ |a article
|2 DRIVER
336 7 _ |a Output Types/Journal article
|2 DataCite
336 7 _ |a Journal Article
|b journal
|m journal
|0 PUB:(DE-HGF)16
|s 1674654664_7297
|2 PUB:(DE-HGF)
336 7 _ |a ARTICLE
|2 BibTeX
336 7 _ |a JOURNAL_ARTICLE
|2 ORCID
336 7 _ |a Journal Article
|0 0
|2 EndNote
500 _ _ |a Preprint is published in Materials & Design
520 _ _ |a This paper focuses on the influence of the High Power Pulsed Magnetron Sputtering (HPPMS) and Direct Current Magnetron Sputtering (DCMS) coating deposition processes, the bias voltage, deposition temperature, and substrate on various properties of the as-deposited state of Cr-Al-C thin films. Three substrates with different coefficients of thermal expansion and electrical conductivity were used. To investigate the microstructure, phase composition, residual stress state, and mechanical properties, ex-situ and in situ synchrotron experiments were conducted accompanied by electron microscopy and nanoindentation. As-deposited Cr-Al-C coatings consisted of amorphous and crystalline areas, with the ratio highly dependent on the deposition process and substrate. The crystalline phase was identified as metastable (Cr,Al)$_2$C. The highest crystallinity was determined for DCMS coatings. Increasing temperature and decreasing bias voltage increased coating crystallinity for HPPMS coatings. The influence of the deposition process and bias voltage was highly reduced for the substrate with low electrical conductivity. In-situ investigations of the stress state of amorphous areas revealed, that those were acting as a residual stress buffer. The hardness and Young’s modulus of the coatings were found to increase with crystallinity and were slightly increased for crystalline HPPMS coatings compared to DCMS coatings.
536 _ _ |a 6G3 - PETRA III (DESY) (POF4-6G3)
|0 G:(DE-HGF)POF4-6G3
|c POF4-6G3
|f POF IV
|x 0
536 _ _ |a FS-Proposal: I-20170652 (I-20170652)
|0 G:(DE-H253)I-20170652
|c I-20170652
|x 1
536 _ _ |a FS-Proposal: I-20180296 (I-20180296)
|0 G:(DE-H253)I-20180296
|c I-20180296
|x 2
588 _ _ |a Dataset connected to CrossRef, Journals: bib-pubdb1.desy.de
693 _ _ |a PETRA III
|f PETRA Beamline P03
|1 EXP:(DE-H253)PETRAIII-20150101
|0 EXP:(DE-H253)P-P03-20150101
|6 EXP:(DE-H253)P-P03-20150101
|x 0
693 _ _ |a PETRA III
|f PETRA Beamline P07
|1 EXP:(DE-H253)PETRAIII-20150101
|0 EXP:(DE-H253)P-P07-20150101
|6 EXP:(DE-H253)P-P07-20150101
|x 1
700 1 _ |a Krülle, Tim
|b 1
700 1 _ |a Ewenz, Lars
|b 2
700 1 _ |a Krywka, Christina
|0 P:(DE-H253)PIP1007377
|b 3
700 1 _ |a Davydok, Anton
|0 P:(DE-H253)PIP1011657
|b 4
700 1 _ |a Stark, Andreas
|0 P:(DE-H253)PIP1011120
|b 5
700 1 _ |a Cremer, Rainer
|b 6
700 1 _ |a Leyens, Christoph
|b 7
773 _ _ |a 10.1016/j.matdes.2022.111535
|g Vol. 225, p. 111535 -
|0 PERI:(DE-600)2015480-X
|p 111535
|t Materials and design
|v 225
|y 2023
|x 0264-1275
787 0 _ |a Heinze, Stefan et.al.
|d Social Science Electronic Publ., 2022
|i IsParent
|0 PUBDB-2022-08066
|r
|t Influence of the Deposition Process and Substrate on Microstructure, Phase Composition, and Residual Stress State on As-Deposited Cr-Al-C Coatings
856 4 _ |u https://doi.org/10.1016/j.matdes.2022.111535
856 4 _ |u https://bib-pubdb1.desy.de/record/491054/files/Article.pdf
|y OpenAccess
856 4 _ |u https://bib-pubdb1.desy.de/record/491054/files/Article.pdf?subformat=pdfa
|x pdfa
|y OpenAccess
909 C O |o oai:bib-pubdb1.desy.de:491054
|p openaire
|p open_access
|p VDB
|p driver
|p dnbdelivery
910 1 _ |a External Institute
|0 I:(DE-HGF)0
|k Extern
|b 0
|6 P:(DE-H253)PIP1081283
910 1 _ |a TU Dresden
|0 I:(DE-HGF)0
|b 0
|6 P:(DE-H253)PIP1081283
910 1 _ |a Helmholtz-Zentrum Geesthacht
|0 I:(DE-588b)16087541-9
|k HZG
|b 3
|6 P:(DE-H253)PIP1007377
910 1 _ |a External Institute
|0 I:(DE-HGF)0
|k Extern
|b 3
|6 P:(DE-H253)PIP1007377
910 1 _ |a Helmholtz-Zentrum Geesthacht
|0 I:(DE-588b)16087541-9
|k HZG
|b 4
|6 P:(DE-H253)PIP1011657
910 1 _ |a External Institute
|0 I:(DE-HGF)0
|k Extern
|b 4
|6 P:(DE-H253)PIP1011657
910 1 _ |a Helmholtz-Zentrum Geesthacht
|0 I:(DE-588b)16087541-9
|k HZG
|b 5
|6 P:(DE-H253)PIP1011120
910 1 _ |a External Institute
|0 I:(DE-HGF)0
|k Extern
|b 5
|6 P:(DE-H253)PIP1011120
913 1 _ |a DE-HGF
|b Forschungsbereich Materie
|l Großgeräte: Materie
|1 G:(DE-HGF)POF4-6G0
|0 G:(DE-HGF)POF4-6G3
|3 G:(DE-HGF)POF4
|2 G:(DE-HGF)POF4-600
|4 G:(DE-HGF)POF
|v PETRA III (DESY)
|x 0
914 1 _ |y 2023
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0160
|2 StatID
|b Essential Science Indicators
|d 2022-11-16
915 _ _ |a Creative Commons Attribution CC BY 4.0
|0 LIC:(DE-HGF)CCBY4
|2 HGFVOC
915 _ _ |a WoS
|0 StatID:(DE-HGF)0113
|2 StatID
|b Science Citation Index Expanded
|d 2022-11-16
915 _ _ |a Fees
|0 StatID:(DE-HGF)0700
|2 StatID
|d 2022-11-16
915 _ _ |a OpenAccess
|0 StatID:(DE-HGF)0510
|2 StatID
915 _ _ |a Article Processing Charges
|0 StatID:(DE-HGF)0561
|2 StatID
|d 2022-11-16
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0501
|2 StatID
|b DOAJ Seal
|d 2023-05-02T08:47:28Z
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0500
|2 StatID
|b DOAJ
|d 2023-05-02T08:47:28Z
915 _ _ |a Peer Review
|0 StatID:(DE-HGF)0030
|2 StatID
|b DOAJ : Anonymous peer review
|d 2023-05-02T08:47:28Z
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0200
|2 StatID
|b SCOPUS
|d 2023-10-22
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0199
|2 StatID
|b Clarivate Analytics Master Journal List
|d 2023-10-22
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0150
|2 StatID
|b Web of Science Core Collection
|d 2023-10-22
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)1160
|2 StatID
|b Current Contents - Engineering, Computing and Technology
|d 2023-10-22
915 _ _ |a JCR
|0 StatID:(DE-HGF)0100
|2 StatID
|b MATER DESIGN : 2022
|d 2023-10-22
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0300
|2 StatID
|b Medline
|d 2023-10-22
915 _ _ |a DBCoverage
|0 StatID:(DE-HGF)0600
|2 StatID
|b Ebsco Academic Search
|d 2023-10-22
915 _ _ |a Peer Review
|0 StatID:(DE-HGF)0030
|2 StatID
|b ASC
|d 2023-10-22
915 _ _ |a IF >= 5
|0 StatID:(DE-HGF)9905
|2 StatID
|b MATER DESIGN : 2022
|d 2023-10-22
920 1 _ |0 I:(DE-H253)HAS-User-20120731
|k DOOR ; HAS-User
|l DOOR-User
|x 0
920 1 _ |0 I:(DE-H253)UDresden-20130903
|k UDresden
|l TU Dresden
|x 1
920 1 _ |0 I:(DE-H253)Hereon-20210428
|k Hereon
|l Helmholtz-Zentrum Hereon
|x 2
980 _ _ |a journal
980 _ _ |a VDB
980 _ _ |a I:(DE-H253)HAS-User-20120731
980 _ _ |a I:(DE-H253)UDresden-20130903
980 _ _ |a I:(DE-H253)Hereon-20210428
980 _ _ |a UNRESTRICTED
980 1 _ |a FullTexts


LibraryCollectionCLSMajorCLSMinorLanguageAuthor
Marc 21