% IMPORTANT: The following is UTF-8 encoded. This means that in the presence
% of non-ASCII characters, it will not work with BibTeX 0.99 or older.
% Instead, you should use an up-to-date BibTeX implementation like “bibtex8” or
% “biber”.
@PHDTHESIS{Serkez:275967,
author = {Serkez, Svitozar},
title = {{D}esign and {O}ptimization of the {G}rating
{M}onochromator for {S}oft {X}-{R}ay {S}elf-{S}eeding
{FEL}s},
issn = {1435-8085},
school = {Universität Hamburg},
type = {Dr.},
address = {Hamburg},
publisher = {Verlag Deutsches Elektronen-Synchrotron},
reportid = {PUBDB-2015-04348, DESY-THESIS-2015-043},
series = {DESY-THESIS},
pages = {143},
year = {2015},
note = {Universität Hamburg, Diss., 2015},
abstract = {The emergence of Free Electron Lasers (FEL) as a fourth
generation of light sources is a breakthrough. FELs
operating in the X-ray range (XFEL) allow one to carry out
completely new experiments that probably most of the natural
sciences would benefit. Self-amplified spontaneous emission
(SASE) is the baseline FEL operation mode: the radiation
pulse starts as a spontaneous emission from the electron
bunch and is being amplified during an FEL process until it
reaches saturation. The SASE FEL radiation usually has poor
properties in terms of a spectral bandwidth or, on the other
side, longitudinal coherence. Self-seeding is a promising
approach to narrow the SASE bandwidth of XFELs significantly
in order to produce nearly transform-limited pulses. It is
achieved by the radiation pulse monochromatization in the
middle of an FEL amplification process. Following the
successful demonstration of the self-seeding setup in the
hard X-ray range at the LCLS, there is a need for a
self-seeding extension into the soft X-ray range.Here a
numerical method to simulate the soft X-ray self seeding
(SXRSS) monochromator performance is presented. It allows
one to perform start-to-end self-seeded FEL simulations
along with (in our case) GENESIS simulation code. Based on
this method, the performance of the LCLS self-seeded
operation was simulated showing a good agreement with an
experiment. Also the SXRSS monochromator design developed in
SLAC was adapted for the SASE3 type undulator beamline at
the European XFEL.The optical system was studied using
Gaussian beam optics, wave optics propagation method and ray
tracing to evaluate the performance of the monochromator
itself. Wave optics analysis takes into account the actual
beam wavefront of the radiation from the coherent FEL
source, third order aberrations and height errors from each
optical element.The monochromator design is based on a
toroidal VLS grating working at a fixed incidence angle
mounting without both entrance and exit slits. It is
optimized for the spectral range of $300-1200$~eV providing
resolving power above $ 7000 $. The proposed monochromator
is composed of three mirrors and the grating. Start-to-end
simulation as a case study of the self-seeded European XFEL
performance with a proposed SXRSS monochromator is
presented. It shows that the laser pulse power reaches a
TW-level with its spectral density about eighty times higher
than that of the conventional SASE pulse at saturation.},
cin = {FS-PS / Eur.XFEL / MPY},
cid = {I:(DE-H253)FS-PS-20131107 / $I:(DE-H253)Eur_XFEL-20120731$
/ I:(DE-H253)MPY-20120731},
pnm = {631 - Accelerator R $\&$ D (POF3-631)},
pid = {G:(DE-HGF)POF3-631},
experiment = {EXP:(DE-MLZ)External-20140101},
typ = {PUB:(DE-HGF)29 / PUB:(DE-HGF)11},
doi = {10.3204/DESY-THESIS-2015-043},
url = {https://bib-pubdb1.desy.de/record/275967},
}